Jedi,
Please forgive me if this has already been answered elsewhere.
I loaded Gene's .dxf conversion into Sketchup and built up the Wharthog model as best I could without instructions - most of it goes together very intuitively. It's a beautiful assembly, and just so happens to fit into our collimated display as if it were destined to be there.
I do have a couple questions and an error pickup, though:
1: Is there a set of step-by-step instructions? After assembly, I have a few bits left over with no immediately obvious location.
2: Is there any reinforcing between the seat pan and back? (I suspect this will be covered if there are instructions available)
3: The slots in the seat pan are wider than the 12mm called out for the seat back. Does something else go in the slot along with the seat back, or is this an error?
4: (pickup) The c-shaped 6mm decorative pieces at the front of the tub section have one leg 12mm longer than the other, interfering with the front tub legs.
I'm working with geneb to get everything cleaned up; once it's all good, I'll upload my Sketchup model.
