Menessis

Ya that's what I am thinking No1....But you can add a 16 bit ADC to the Leonardo (I think). That's what I will look into next. Well that didn't take long.....Check this out:->

My Cougar specs say 16 bit resolution on x and y and 14 on the throttles. So that's 2 to the power of 16 or 2 x 2 x....16 times right? Which is 65536. I have been tinkering with Arduino's now for a while and was thinking of getting a Leonardo to use for a Huey setup. Full size. So I see here, a library stating it has 16 bit joystick support. OK cool I'm thinking. But the Leonardo says it's 10 bit. So what am I missing here? Do I need an external Analog to Digital Controller add on? Thanks Menessis

For a long while we couldn't use TACAN Y for the tankers. Now I see that working but for some reason I'm not getting Call Sign up in the HUD? Also the HSI is displaying Bearing information, and CallSign even though I don't have TACAN boxed. Has something changed recently? Thanks Menessis

Thanks Frost

Hello Silver. So Zoom Normal is the num pad enter. Is this what you are talking about? Menessis

I'm trying to setup the FOV (not zoom or Snap Views) for each aircraft. The goal is to be able to smoothly see the cockpit correctly using my TIR . I get it looking good but can't seem to save it. R CTRL + Pause Break brings up the specs on screen. The FOV value there doesn't change as I make realtime changes. So I guess I'm missing something here. I hope there is a solution! Thanks Menissis

While using the 154a's and setting up the HT I see new parameters. I have looked for info about the use of the Heading and Velocity settings. Can't seem to find anything. Is this not implemented yet? Thanks Menessis

I'm using the right shift and right Ctrl along with the / and* on the num pad to move my head position forward and aft. I can't figure out if it saves that info with R Alt + num 0 or not.

Thanks RazorBack. I have that on. After a lot of tinkering I think it has to do with how I am seated when I tap the button to re center my TIR?

While trying to tweak my head position and my Track IR profile I found out that the "R ALT + Num 0" isn't saving the settings. I get back in next time and I'm sitting all the way back again. So what's the trick?

My comms switch is sticking. Any way to lube it and what to use? Menessis

I did figure it out by going through something I had hit upon a few days earlier. I comes down to the order in which the way point actions are put in, ie "bomb" can't come before "reaction to threat" otherwise they must bomb before they do the next instruction. Menessis

Hey Habu_69..Thanks for the helpful tip. The thing is I did search it and came up with very little. Maybe you can help me with my searches?

Hi Nealius. I used your numbers along with setting the bombers to Evade if shot at. They will fly the route and bomb the target. BUT! if I have a even a hint of a SAM they fly the route, fly right over the target, drop chaf and flares but no bombs! The SEAD mission was in support of the bombers using the new PB mode. We have flown it where not one SAM is fired but no bombs are dropped. Menessis