[F16 FCR]

9 hours ago, Sacarino111 said:

Hi. I jave seen your track, and theMIG is flying away from you, so the detection range would decrease, maybe considerably compared to when it is flying towards you. Try a newe mission with easy tergets flying your way and at same altitude and check if it stills doing nothing.

Your radar settings where ok; antena and azimuth correctly set, range also ok. Only think is the aspect of the target. As  ice41 said, I can't tell if it is acurate or not.

Saludos.

Saca111

Ok, will do....

[F16 FCR]

Ok, I have mission with MIG 29 as target, I started at approx 35000 feet, while MIG was at 25000 feet. We started at 50 NM out. 

Even when I knew where to look, I couldn't get my radar to find MIG until I descent to 25000 feet and came close to more or less 15 NM. Based on various tutorials, I should see MIG sooner than that.

 

By the time I shoot my first AMRAAM I was basically WVR.....

 

I am not sure if I am doing something wrong here.

radar track mig 29.trk

[F16 FCR]

32 minutes ago, razo+r said:

What about your radar range scale, antenna elevation, azimuth coverage and amount of scan bars?

Well, I checked all of those, I even had one mission where I was flying at same altitude with target I think it was 30000 feet and I tried to adjust azimuth, elevation, changed TWS and RWS and still I didn't saw target.....

27 minutes ago, BIGNEWY said:

Hi

 

Welcome to the forum, 

with bug reports we usually ask for a track replay, this can be saved after you exit a mission during the debrief screen.

 

Please make the track replay as short as possible to show the issues and we will all take a look. 

 

thank you

I will do those ASAP and post it here.....

[F16 FCR]

Hi guys, 

 

I am new to the DCS as player but I been observing what is happening in DCS for a while.

 

So, I installed F16C and at the moment I am going through training missions. All of this is clear to me, but when I go to mission editor, I create just target practice mission so I can practice all routines to engage in BVR fight.

 

This is where I noticed problems, I created firstly 2 MIG 21 and I tried to engage them in BVR. However, my radar couldn't find any targets until I approached at about 15 NM, when is too late to engage 2 MIG's.

 

So to explore more, I modified mission so I start at 40000 feet, with 2 MIG's dead ahead at 80 NM and 30000 feet, and still my radar couldn't find target in RWS mode, I tried to swap to TWS mode but still nothing, same, when I came closer to about 12 NM I had target found on radar.

 

Just to be sure I tied another mission where I put bigger target, AN 22 same story. 

 

I tried with AWACS on my side, and I can see target on the radar but I cannot do any thing with it again until I came very close.

 

This is only doing in mission editor. When I go to instant action, and select free flight, I can scan everything as it should.

 

Am I doing something wrong here?? I watched many Youtube videos on that subject, and I cannot see that I am doing something wrong.

 

Cheers...