kmaultsby

This question is somewhat related to a question I had before, but it's new. I'm trying to get used to this Stick for Air Refueling. For now, I have my settings set at Deadzone 3 and Curvature at 10 for both pitch & roll, and I am all over the place. I know this takes practice, but do these settings seem OK? Any suggestions?

Thank you

The wife gave me the ok to purchase a new monitor for flight sim. My Graphics card is RTX4070, I am looking for monitor between 32 and 42 inches. My budget is $500 or less.

Thank you, MAXsenna and mkdI2010, but I want to make sure I understand. When you say set turned off deadzones, we are not talking about Axis Tuning in control settings, correct? My other question is, what do you have your Axis Tuning settings?

In DCS in the Options window under the Special TAB for the F16, should the Pitch & Roll Axis Force Gradient be checked on or off. I am using the WINWING Orion2 ViperAce(EX) Joystick. This is the Non Force Feedback.

What is the keyboard command for Active Pause for the F16. Where find keyboard command list?

Hello all, I have the Legend MIP with all three MFD's. When flying the F16 I can raise the brightness on the left and right MFD'S with the brightness control, but for the HSI in night mission the display is dark. Do you have to set display brightness manually in SimApp Pro?

All a friend is looking for a good all around Throttle I ask him to joint the forum but I am asking this question for him. The aircraft he fly's F16 F18 and MSFS. Would this be a good Throttle for him?

Thanks

No, It is not for the force sensing. Let me give an example. Learning to do Air refueling and tried different settings and what is happening for pitch nose down is ok but nose up it is acting like have a dead zone compare to nose down. I have to give more input nose up and went it does move it is too much input. I did recalibrate, but still didn't help.

Sorry I don't know what happen, I thought I was in the WinWing forum. Dos Thank you very much. A lot of information. I am just using the regular F16 stick. " "Pitch & Roll Axes: Apply a negative curve between -4 to -15. This adjustment compensates for the Viper's hardcoded force-sensing curve, offering smoother and more precise control, particularly in the center zone. reddit.com+4reddit.com+4reddit.com+4" Is this just for the force sensing.?

Thank you very much for the advice and suggestions.

Looking for good starting control settings points for this joystick for the F16 in DCS. Axis, Saturation, dead zone. Any recommendation or suggestions is greatly appreciated.

Thanks for the info.

All need advice on a good starting point to set up the ViperAce Stick for the F-16. I am all over the place with formation flying and AA refueling. Advice on the Axis tuning.