TardFarmer

I checked and I do not see duplicates anywhere. The throttle works fine But as soon as I move the stick to roll or pitch it locks on the right hand side in the tuning area and does not revert til I close the game and restart, rinse and repeat. Thanks for the help though!

Ok I picked up DCS blackshark the other day, I had no clue a decent Helo sim was being released and I was pumped when I saw this as I have not played a decent one since Longbow 2. I found the axis control settings and have the throttle mapped and the x and y axis. along with my CH rudderpedals. I calibrated everything in windows beforehand and all seemed good. When I go into the game the rudders work but pitch and roll do nothing until I push forward all the way on the stick. As soon as that happens and I let go it automatically pulls all the way back and then locks there and I proceed to do reverse somersaults until I hit the ground. If I go and look at the mappings in axis I see the Y axis is stuck all the way to the right of the axis tune panel. If I start the game over and check the dot is sitting right in the middle where it should be until I push forward with the stick then it pulls all the way to the right and locks there until I restart the game.. Any ideas? Vista 32 4 gigs of ram Saitek x45 with latest drivers from Saitek, I also tried basic winodws drivers CH products rudderpedals track IR2 which I found out the hardway does not work in blackshark either.... lame