MFD zoom axis

[S77th-konkussion]

Doesn't seem to work quite right in the 25T. As I understand it- there are supposed to be 3 zoom levels- 5x, 8x, & 23x. It fails to zoom to 8x. I have a 5, I have a 23 when I map that axis to Rotary #2 on X45. The button command seems to work.

 

Flankers test out fine- all levels of MFD zoom seem to work.

 

The A10 Maverick D zoom does not seem to pick it up either.

 

If I just push the button- it works. If I assign button commands via bands- it works too.

 

While I'm at it- the "trim roll" axis takes an assignment but will not hold position- it returns to center. (using rudder rocker- X45)