Saitek X-55 Mode Switch

[Donut]

I received a new Saitek X-55 from Santa which I am in the process of setting up for the A-10C. Everything is good to go except for the Mode Selector switch. Does anyone know of a way to use the Mode Selector switch as three individual buttons? Also, I cannot even get DCS to recognize any input from the Mode Selector switch. In the controls setup in DCS, I turn the selector but do not see any corresponding input registered. I am sure there is an element of user error here. Hopefully someone with more wisdom can offer some advice. Thank you!

Edited December 29, 2015 by =BJM=

[Haukka81]

I received a new Saitek X-55 from Santa which I am in the process of setting up for the A-10C. Everything is good to go except for the Mode Selector switch. Does anyone know of a way to use the Mode Selector switch as three individual buttons? Also, I cannot even get DCS to recognize any input from the Mode Selector switch. In the controls setup in DCS, I turn the selector but do not see any corresponding input registered. I am sure there is an element of user error here. Hopefully someone with more wisdom can offer some advice. Thank you!

 

It works fine but do not install saitek software, only drivers and it works fine.

 

I use mode to shut down engines etc.. M1 is left engine M2 is nothing and M1 is Right engine