RK3 and PCA

[Flagrum]

There are a few issues with the PCA and rockets (DCS 2.2.0.12843, but 1.5.8 is also affected, iirc):

 

1. If no A/A weapons are loaded, the first PCA button is assigned RK3. According to the manual, the first button should only be assigned MAG (if loaded).

2. If 4 x RK3 is loaded, PCA 1 and PCA 2 show "S" and "P", when clicked. PCA 1 should show nothing (see 1.), and PCA 2 should probably show RK3, but is empty.

3. If RK3 is loaded at the outer pylons and A/A at the inner pylons, the PCA only shows INT instead of EXT. In this configuration it is not possible to fire the rockets, although HUD symbology suggests otherwise.

 

Perhaps not directly RK3/PCA related:

4. Loaded 4 x RK3, selected RK3 together with INT and EXT, TAS and RS active, master arm ON: HUD symbology is incomplete, showing only the 4 tick marks, but no range circle. This lasts a minute or so right after take off until the correct symbology is eventually displayed. Firing rockets is possible, but the (incomplete) HUD cue is off - probably just showing bore sight position.

 

I noticed, that during the time the issue is present, the radar screen shows a blinking P. That means, the radar (TAS) is still warming up? But shouldn't active RS still allow to get a working CCIP solution?