TDS TM Warthog

[=Pedro=]

Is there any chance to slow it down or give it less authority somehow because setting the mark point over a2g target on HUD is very very unprecise. I can tweak it a bit using curves and saturation sliders but after that, I'm not able to use it fast enough to lock a2a targets on radar page on the right DDI.

 

Yes, I can map another HAT on the Warthog throttle or stick but they are only buttons not a real axis ministicks. There is an upgrade kit but Im not sure if it's a good solution to my problem.

 

https://deltasimelectronics.com/products/thumbstick-slew-sensor-adapter

 

S!

[christiankirk81]

I set a deadzone and saturation, no curves. I set a deadzone of around 13-15 for both x and y axis, and set saturation to around 40. It's a trial and error phase. I just mirrored exactly how I had it as a slew on the A10C.

[=Pedro=]

I set a deadzone and saturation, no curves. I set a deadzone of around 13-15 for both x and y axis, and set saturation to around 40. It's a trial and error phase. I just mirrored exactly how I had it as a slew on the A10C.

 

Thanks for sharing this info with me Christiankirk81! Are you still able to quickly use it as a2a radar TDC to lock targets?

 

S!

[=Pedro=]

The problem also is, the marker is moving itself a bit while closing to the target so forget of marking the target from more than 3 nm :( At least dumb bombs not overshooting hundreds of meters like in M2KC (CCRP) :D

Edited June 11, 2018 by =Pedro=