Tj1376 Posted June 15, 2019 Posted June 15, 2019 I must be doing something wrong. When I enter precise coordinates into my waypoint, then waypoint designate the waypoint and go over to the JDAM in TOO mode, the coordinates do not match (and the JDAM misses the target.) What am I doing wrong - ive watched Wags video on this probably three times and I cant find something I am doing wrong, but the coordinates do not carry over to the JDAM correctly. If it matters, its an air start. See attached picture of the HSI waypoint coordinates (you have to take my word that this is the waypoint I target designated) and then compare them to the coordinates the JDAM has displayed on the screen in TOO mode. It didnt matter if I moved from TOO1 to TOO2, the coordinates remained the same. :( What am I doing wrong? TJ
Tj1376 Posted June 15, 2019 Author Posted June 15, 2019 It sounds very much like this issue... https://forums.eagle.ru/showthread.php?t=242762 I bet this persons TOO mode is way off because he has the same issue I do (where the coordinates in TOO mode do not match the coordinates in the waypoint) TJ
Recommended Posts