802AKG F10 waypoints procedure?

[Kumabit]

Sorry I just realized that I have posted this problem already. Please remove this post. Sorry

 

I found out that in order to use the MAN mode of the 802AKG, the following procedures must be made, or the missile won’t recognize the waypoints. I am wondering if step 4 are necessary in real life? The missile won’t recognize the pasted waypoints automatically. It really seems like redundant.

 

Step 1, Load the missiles and create waypoints on F10 map

Step 2, Asking for a DTC card update and load the information

Step 3, Copy and paste waypoints 36, 37, 38...to the empty waypoints slots 30, 31, 32...

Step 4, Unplug the DTC card and ask for an update again, then load the information

Edited December 22, 2019 by Kumabit

[Rlaxoxo]

I noticed that Route points are not getting updated if you copy-paste them from waypoints or markpoints as well.

 

Copying Waypoint or mark point to PP 36-39 get updated and work just fine however.

[witness_me]

you can create a route point by clicking on mark label in the f10 map/some location on the map and then type "RP1" (without the double quotes) inside text box of the label you just created. Same goes for preplanned points (add PP1)

 

 

check out chuck's guide - everything is detailed there

[Rlaxoxo]

you can create a route point by clicking on mark label in the f10 map/some location on the map and then type "RP1" (without the double quotes) inside text box of the label you just created. Same goes for preplanned points (add PP1)

 

 

check out chuck's guide - everything is detailed there

 

I know all of that, however, I can't do that while I'm flying in the air and I have a friend that found a potential target to destroy.

 

EDIT: One more thing to report.

 

If you make multiple PP-points and try and suing CORD mode in 802-AKG you can only use PP1 (Dest 36)

You can't switch between the different PP's

Edited December 27, 2019 by Rlaxoxo

[witness_me]

I was responding to the op

 

 

"Step 1, Load the missiles and create waypoints on F10 map

Step 2, Asking for a DTC card update and load the information

Step 3, Copy and paste waypoints 36, 37, 38...to the empty waypoints slots 30, 31, 32...

Step 4, Unplug the DTC card and ask for an update again, then load the information"

 

 

letting him know that he can create RP's straight from the map or the mission planner

 

your problem seems to be different than the op's: will the jf-17 support sharing SPIs etc via datalink/is the datalink fully fleshed out yet. Probably deserves it's own thread?

 

As a workaround I'd suggest you have your buddy laze his target, then you enter lss and acquire it, you can then copy the coordinates into a markpoint etc