Virpil Alpha and MongoosT50- Pinned X pitch axis and Pinned Y roll axis

[jojo_tapp]

Hello, I'm a complete noob (literally just downloaded DCS and calibrated my Virpil controllers with their software yesterday).  In the attached screen shot, you'll notice that X and Y are completely pinned to the right.  Movement of the yoke produces very minimal movement of the position bars.  

 

I've used Virpil's VPC software to calibrate the yoke and even tried to see if the Axis Tune feature would provide some help, but I'm unable to get the position bars to read normally (meaning centered when the yoke is centered).

 

Any help or suggestions would be greatly appreciated.  I'm also glad to answer any questions or provide photos/screenshots if it makes troubleshooting easier.

 

Thanks!

Jojo

 

PS I tried using the search feature in the forum but was overwhelmed with the amount of posts and couldn't narrow the search results down to this specific issue.

2021-05-04_12-27-58.pdf

[The LT]

How are you calibrating? Are you moving the stick when you engage the calibration mode?

[jojo_tapp]

1 hour ago, The LT said:

How are you calibrating? Are you moving the stick when you engage the calibration mode?

 

Thanks for your reply, LT.  Yes, when in the VPC Configuration software, I'm going through the full range of motion for yaw, pitch and roll.  When complete, all of the indicators on the profile read 50% (centered).  I have attached the axis screenshot

2021-05-06_9-52-15.pdf

[jojo_tapp]

I went back and started over with VPC Configuration and was able to get all axis' (or axises?) to operate as designed.  Thanks for your help @The LT!

 

Jojo