NOWIS Posted May 26, 2021 Posted May 26, 2021 (edited) Hi, I cant find axis for these two turn knobs: "HDG Set Knob" "CRS Set/Brightness Control Knob" (See Picture below) I wish they would be in the control options to assign two axis of my simpit to them. Thank you for this amazing game! If I`m just blind i`ll be happy if somebodey would tell me how to set up these axis. Fly safe! NOWIS Edited May 26, 2021 by NOWIS 1
SpaceMonkey037 Posted May 27, 2021 Posted May 27, 2021 These knobs are encoders, not axis. They rotate many times for a 360 degree "input". I don't think there currently is a mappable axis for this, although it shouldn't be too hard for ED to make one in my opinion.
NOWIS Posted May 27, 2021 Author Posted May 27, 2021 (edited) Ah makes sense. Thanks SpaceMonkey037! Ill figure smth out. Maybe i can map a certain resistor ranges in the Arduino sketch to "Increase" and "Decrease" and between the two one for "Standstill". That way I`d be able still to use the two resistors that I just added to my simpit... EDIT: Ok, after looking up encoders i just ordered a few. I will replace my potentiometers with them. Thats the way it should be. Edited May 27, 2021 by NOWIS
SpaceMonkey037 Posted May 31, 2021 Posted May 31, 2021 On 5/27/2021 at 12:33 PM, NOWIS said: Ah makes sense. Thanks SpaceMonkey037! Ill figure smth out. Maybe i can map a certain resistor ranges in the Arduino sketch to "Increase" and "Decrease" and between the two one for "Standstill". That way I`d be able still to use the two resistors that I just added to my simpit... EDIT: Ok, after looking up encoders i just ordered a few. I will replace my potentiometers with them. Thats the way it should be. Hope it works out for you!
Recommended Posts