sll Posted June 17, 2021 Posted June 17, 2021 I have followed the start up process on the tutorial 20 times . But the Gyro lights keep flashing. I have reset, I have the alignments on etc etc. Not sure how to get around this. Nb I have followed the start up step by step 15 times.
lmp Posted June 17, 2021 Posted June 17, 2021 Did you hold down the cage buttons for a moment rather than just pressing them?
sll Posted June 17, 2021 Author Posted June 17, 2021 I can get the flashing off by using the blink switch but I can not get them exterminated and aligned. Yet in the tutorial I have no issues? Yes, held them down as per tutorial etc, no issues..
sll Posted June 17, 2021 Author Posted June 17, 2021 Got it, reset the Gyros, The AC power was not on mains . Seems to affect it.
sublime Posted June 18, 2021 Posted June 18, 2021 Hey can you explain what you did? If I autostart I have the same issue?
MIlleratic Posted June 18, 2021 Posted June 18, 2021 Turn on the 2 transformers on the right side power panel then on the left upper part of the dash you need to cage the 2 gyro's to get the lights to turn out. None of the autopilot channels work if this is not done.
Tiger-II Posted December 28, 2022 Posted December 28, 2022 I think there is a bug. The middle position is AUTO, so it should work regardless, but it only works if you manually select MAIN. Motorola 68000 | 1 Mb | Debug port "When performing a forced landing, fly the aircraft as far into the crash as possible." - Bob Hoover. The JF-17 is not better than the F-16; it's different. It's how you fly that counts. "An average aircraft with a skilled pilot, will out-perform the superior aircraft with an average pilot."
Recommended Posts