X56 Rhino deadzone einstellungen

[CarloVecchi]

Moin Moin zusammen,

ich habe mir vor kurzem den X56 zugelegt (nachdem er wieder lieferbar war).

Jetzt bin ich auf der Suche nach Erfahrungen mit dem Einstellen der Deadzones.

Ich habe am Stick auf der Y Achse 10 eingestellt, auf der X Achse 15 und auf der Z Achse 5.

Damit bin ich erstmal zufrieden. Aber mich würde interessieren, ob es da von euch Tips gibt für eine bessere Einstellung des Sticks (Kurven etc), 

aber auch des Throttles bzgl der Deadzones.

 

MfG, 

 

Carlo (Soulfreak)

[BadMoose]

Hi Carlo,

You will find the dead zones challenging on the X56 in my experience when it is in factory spring setup due to the poor centering with the factory spring (I also use it still currently) my recommendation is to install an external spring modification, remove the factory spring and you will find you can set minimal dead zones and good curves depending on the aircraft you are flying (curves vary between aircraft depending on the responsiveness of the control surfaces and flight model) and it removes the issue with the center play the X56 has.

I used the following as the basic guide to modifying mine (although I adjusted it a bit to suit me):

After the modification I generally run a dead zone of 2 and a curve between 12 and 20 depending on the aircraft.

Cheers,

Matt

Edited October 20, 2021 by BadMoose

[CarloVecchi]

Am 20.10.2021 um 11:48 schrieb BadMoose:

Hi Carlo,

You will find the dead zones challenging on the X56 in my experience when it is in factory spring setup due to the poor centering with the factory spring (I also use it still currently) my recommendation is to install an external spring modification, remove the factory spring and you will find you can set minimal dead zones and good curves depending on the aircraft you are flying (curves vary between aircraft depending on the responsiveness of the control surfaces and flight model) and it removes the issue with the center play the X56 has.

I used the following as the basic guide to modifying mine (although I adjusted it a bit to suit me):

After the modification I generally run a dead zone of 2 and a curve between 12 and 20 depending on the aircraft.

Cheers,

Matt

 

Thank you for your replay.

I use the hard factory spring and i´m ok with it.

Maybe you can give me advices for the curves you use on the aircrafts & how do i import an setting for a specific ac. 

Sorry but I´m still on the start with using the x56.