Jump to content

Recommended Posts

Posted

Has anyone had an issue with a GVL224 controller where one of the axis inputs stopped working or has starting exhibiting a lot of "noise" (this is, excessive jumping up and down of the axis)? That is one of the problems I am now experiencing with mine - in addition to one lever not responding, now I have the throttle not responding correctly (i.e., lots of noise).

This all started with an unrelated issue where I had to replace the USB connector. After disconnecting all of the axis cables (so I could remove the board and repair it) and then plugging them back in after fixing the USB connector, all of a sudden I now have the problem described above - an entirely non-working lever and another one where the response from the lever is all over the place.

I am in contact with Vitaly (aka GVL224), and he's suggested that there might either be a problem with a contact on the board, a broken wire somewhere, or possibly dirt in one of the 3-pin connectors. Is there anything else that might be the case or is there anyone here who might have experienced a similar problem? I've looked closely at the wires, but nothing seems to be broken. Are these 3-pin connectors fragile enough that a wire might be broken inside one of them?

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...