Cannot see where see the CPG is looking after issuing the "Slave command"

[Theloaf]

Last night, I somehow did something (no idea what) that would not allow me to see the CPG "hatched cross" symbol. This made it impossible to issue to "slave/look here" command to George. He could find targets but I was unable to see what he was looking it. Any idea what switch or setting I changed? 

[tech_op2000]

As Pilot, the dashed cross (cued line of sight reticle) is your acquisition source. To see where George is pointing the TADS you want to set TADS as your source. 

[Theloaf]

Assume I'm dumb/new, How do I set TADS as my source. I know how to pull up TADS on the MFD and do have that pulled up. 

[tech_op2000]

on the WPN page or TSD, on the right bottom. you will see ACQ. click it, then select whatever source you would like.

Casmo Has a great video on this that he just released. It is from the Gunner's perspective, but much of the ACQ info is similar for the pilot.

Some notes not covered there

- The pilot will always see his ACQ source.

-The gunner will only see it if he slaves his sight with the slave button

Edited March 27, 2022 by tech_op2000

[Theloaf]

Thanks I'll have to watch that. I'm sure I hit the WPN switch and messed something up.