Jump to content

Recommended Posts

Posted

I am trying to assign my throttle on the Logitech 3D Pro to the Thrust command on the FA18C.  I'm doing this through the Axis Commands.  I click on Access Assign and go to the Thrust row, and then to the Logitech column, but when I move the throttle on the joystick, it's not registering.  Am I missing a step?  Any guidance will be appreciated.   Thanks.

Jim

Posted

I assume you're clicking on the appropriate cell in the Logitech column (for the thrust).  Make sure you move the throttle on your joystick fully forward and back.  If you only move it a bit it may not register.  Move it to both ends.  If that doesn't work, right click in the cell and it should give you a dropdown to pick what you assign it.

Posted

Thank you so much!  I went back in and tried it again.  The levers still didn't register, but then I right clicked as was able to assign it to Joy_Slider1 and it worked!  Appreciate your help!

Have a nice holiday.

Jim

 

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...