Schwarze 8 Posted February 27, 2023 Posted February 27, 2023 Hi, i have a problem regarding the default setup of the axes of my new vpc mongoosT50 CM3 throttle. DCS only recognizes the throttle axis rY when i move BOTH back and forth. If i only move one back and forth it doesn't recognize either of them. This makes it impossible to assign the throttle axes to dual engine module like F18 or A10. Does anyone know how to configure them so that they behave as 2 individual axes?
Athlon Posted February 28, 2023 Posted February 28, 2023 (edited) Did you calibrate axes in the Virpil software and save to device. Also in the DCS settings is there a little box in the axis tune section, (bottom of screen) saying Rx or Ry? If you press it it may also change to X or Y Edited February 28, 2023 by Athlon
Schwarze 8 Posted March 3, 2023 Author Posted March 3, 2023 SOLVED: It was an issue with the doubleaxes lock. After i reconfigured the axes lock function to "ON" it worked and both axes have been recognized.
Recommended Posts