Vince Posted June 29, 2023 Posted June 29, 2023 I'm running into a weird issue with the LHC TCP PRESS and RHC TCP PRESS when flying as WSO in multicrew. The buttons are mapped and they register correctly in the DCS Adjust Controls screen. But I'm unable to designate targets, trigger HD map radar scans or anything that uses TCP PRESS on either of the WSO controllers. Is this a "me" problem (Like i didnt know that LHC/RHC CASTLE is NOT the castle for the WSO, but you have to bind LHC/RHC COOLIE to get castle functionality) and I need to bind another control? Or is the TCP PRESS for the LHC/RHC not working? My pilot can lase and map normally from the front. My apologies, I've been trying to figure this out for the past 4 evenings and I have no idea what to try anymore. Thanks for the help.
Solution Zboboinator Posted June 29, 2023 Solution Posted June 29, 2023 You need to use the trigger half or full instead of tdc press Tdc press for pilot =trigger for wso 1
Vince Posted June 29, 2023 Author Posted June 29, 2023 Thank you for your reply, I will try that. Is the Trigger for the LHC or the RHC? Or does it activate the action for either? Just trying to figure out if i have to configure two triggers.
Zboboinator Posted June 29, 2023 Posted June 29, 2023 (edited) If you have the sensor ( pod of radar) on the left mpd of mpcd use the left trigger and same for the right side Edited June 29, 2023 by Zboboinator 1
Vince Posted June 29, 2023 Author Posted June 29, 2023 5 hours ago, Zboboinator said: You need to use the trigger half or full instead of tdc press Tdc press for pilot =trigger for wso Thank you that resolved that issue. Is this document in the manual? I couldnt find it.
Recommended Posts