Justin1Ntime Posted August 27, 2023 Posted August 27, 2023 (edited) Hi Guys what are you using for DCS setting on the Pimax Crystal? I find it only really is good if you can get that 90FPS but that means turning resolution way down to the point it doesnt look that great. I have a 4090, 13000K I7, 30Gig of 6000 DDR5. I have FFR set to balanced, OPen XR with NIS and 20% Sharpening, and RR 75% It seems the only way to make it smooth is to turn down the render settings to low in the Pimax tool then turn graphics to medium (ish) with a few tweaks here and there. IE preload radius ect. If I turn RR up to balanced, I am in the 80 FPS and looking at the ground, I start to see it get jittery and start to see some ghosting on the buildings. What is everybody else doing for DCS settings? There does not seem to be really good settings like the HP and Quest with ASW/MR. Smart Smoothing on the Crystal makes the jutters really bad but does get rid of the ghosting wich forces you to run the FPS at the same rate is the refresh rate and in DCS 90FPS with decent clarity is looking to be impossible. Are other crystal users seeing that or do I have something configured wrong? Keep in mind this is when flying over large cities doing A2G. Edited August 27, 2023 by Justin1Ntime
matze140 Posted August 28, 2023 Posted August 28, 2023 Pi-Tool RR 0,75. DCS: medium/high. Flat ground shadows, MSAA Off, Clouds Standard, OpenXR Toolkit: RR UNTOUCHED, Foveated rendering custom setup. 90+ FPS 90% of the time. Some 80-90 FPS the rest of the time. I dont mind the missing MSAA because the resolution is so high and the image so clear. In 0,75 RR its so much clearer than my old Reverb G2.
Recommended Posts