Acquire on The Move/Offset Acquire: Unable to slew cursor after slaving MMS to Target Point or Waypoint or Using Search Mode

[Skeleboners]

Entering Acquire On the Move or Offset Acquire mode after slaving the MMS to a target point or waypoint, or using search mode, then using the MMS Manual/Slave mode button to return to manual mode causes the MMS Line Of Sight control to no longer slew the Acquire On the Move/Offset Acquire cursors as expected. The modes can be entered as expected, but the cursor in either mode remains frozen to the center of the MMS field of view. Returning the MMS mode to FWD and commanding the MMS to slave forward, then returning to manual control restores expected behavior in both modes. The MMS need not slew all the way forward in this case- simply commanding slave, then quickly returning to manual mode is enough to restore expected behavior.

Tested using axes to control MMS line of sight as well as buttons. Also tested target point creation by lasing and storing, dropping a target point in flight using the bob up button, manually entering a target point on the HSD, as well as mission editor created target and waypoints- unexpected behavior is present in all cases. Wasn't able to test using target points sent over IDM. Unexpected behavior is present in both a cold started aircraft, and an aircraft set to start hot from parking. All testing done on the Syria map with the mission editor default time, weather, etc.

Tracks available on request, but it's a pretty simple problem to reproduce.

[LorenLuke]

Known and reported issue. Should be fixed in next patch.