Model98 Posted October 22, 2024 Posted October 22, 2024 (edited) Control Monitor Panel Test Knob Has One Too Many Settings AND Dot Balance Mode Is Also Wrong . “ Dot Bal “ Should Be Springloaded and Jump Back To “ Test 0 Mode “ When Released Which Currently It Doesn’t . between “ Dot Bal “ And “ Test 9 “ There Is a Selectable Position/Mode That Shouldn’t Be There Indicated By Red Circle In Picture Below , The Dimension of Panel Also Must Be Revised on another note , is BIT 0 For Aim Dot and Range Rate Calibration Implemented ? I Cannot Get It To Work and For DSCG BIT The 8 Shades Only Appear When Radar Is In Operate mode . Edited October 22, 2024 by Model98 -Made a Typo , DSCG To DSCG On Last Paragraph
Recommended Posts