Loadie Posted December 21, 2024 Posted December 21, 2024 Hi all, back again with yet another issue I’m having. Here is my setup today, I’m waiting for my 9800X3D to arrive so I can install the new PC. But until that arrives I’m having a massive issue. Oh yeah, my setup, I7 11700K 64GB Ram, RTX308-Ti FTW3, with 3 x M.2 SSDs. Issue; when in DCs and flying the Apache the monocle is way too high in my view, the heading take can barely be read, even with the headset set to all different angles, same results. Then I try to use George AI and the AI pop ups are set to victimless, not horizontal. The second pop up is so high 1/2 isn’t even in my view. I’m assuming it’s some setting I have in either DCS or Oculus software. someone with the Quest 3 that’s not having theses issues, can you post your settings, so I can compare and hopefully resolve the issue? I have a ticket in with ED, but they’re asking for photos or video of the issue. When I try to do that. I press the oculus button and pull the trigger, just like the manual says, in my case I get the DCS folder in VR pop up and it asks me if I want to recenter the view or quit DCS. When I try to take a photo or video, I pull my headset off and the eye pieces immediately turn off, so I can’t take a screen shot, photo or video. i asked ED if they could add something so we can adjust the monocle, they said they were currently discussing the issue; however, not enough people are complaining about it, so they’re not inclined to make a change. They’d look at my issue for sure but I need to supply evidence, which I can’t!
Recommended Posts