Islari Posted February 11 Posted February 11 Hello, It's been multiple times that the INS align process is completely bugged. I follow every procedures found on the manual, and the issue also happened during the WSO Cold Start tutorial. It seems that the ALIGN light never goes blinking when the issue happens, I waited over 30 min with a steady align light in the tutorial (so you can assume every steps were perfects as it is guided at least for this example). I finally switched the INS knob to NAV and it seemed to have validated a BATH alignment at least. Sometimes everything works as intended, but sometimes not, with the exact same procedure.
Zabuzard Posted February 11 Posted February 11 Usually this is due to ur spawn point or something slightly moving you during the alignment - in which case the INS reacts correctly by taking veeery long. Do you happen to have a track at hand so we could verify what exactly happened? Cheers
Islari Posted February 12 Author Posted February 12 On 2/11/2025 at 3:37 PM, Zabuzard said: Usually this is due to ur spawn point or something slightly moving you during the alignment - in which case the INS reacts correctly by taking veeery long. Do you happen to have a track at hand so we could verify what exactly happened? Cheers Hello Zabuzard I'll try to find a track to share with you Just in case about the slight move we generally perform the alignment while chokes on to prevent this problem, so no move intended. 1
Zabuzard Posted February 12 Posted February 12 Hello Zabuzard I'll try to find a track to share with you Just in case about the slight move we generally perform the alignment while chokes on to prevent this problem, so no move intended.Wheel Chocks unfortunately don't prevent mini movements in those situations. DCS shenanigans
Recommended Posts