Virpil Configuration TOOL (20250313) issue after updating to this version.

[Targanon]

Hi Everyone,
I have a fair few devices

VPC MongoosT 50CM3 Throttle
VPC PAnel #1  (plugged into Above)
VPC Rotor TCS Plus + VPC Apache-64 Collective Grip
VPC AntiTorq Rudder (Plugged into Above)
VPC VPC MongoosT 50CM3 Base + VPC Constellation ALPHA-R
VPC ACE Interceptor Pedals

So Because of how VPC devicves worked in teh past all of these devices would work hapopily with each other and the daisy chained Devices would show up as part of the Device it was plugged into..

thus allowing me to have such qualityu of life devices like 
Mouse
Keyboard
Speakers 
Microphone
VR Pimax Crystal Light
all plugged in at the same time on my computer.. 

and go fly and not have to worry about anything.

Well around the same time.. as I updated my VPC Config tool to the one stated earlier.. 
 I actually got an RMA confrimed to the PCL for a issue I had been having for a while.. told it would only be a couple of weeks I was like ok..
turns out it actually took 5 weeks.
in this time and numerous windows updates etc and my devices not being used and unplugged the whole time.. and never actually using them before snd the VR away.. so no flying DCS.

when the VR came back I egerly jump in to find all my binding have gone waked.
after a long process I finally noticed the extra devices in the binding page.. that led me to the VPC config tool and everyu was fine there.. so then I looked at windows Gaming devices and it was the same as DCS all of teh paired/chained devices are now showing up as doubles this causing massive conflicts for me in DCS bindings.

so I set about contacting VIrpil for some help as I had even rolled back my Config tool to the prior one I had been using with no luck.. so I went back further for 4 more times nothing got better.. 

After a couple of days Virpil support Finally got back to me.. 
I know they are super busy and all. but seriuosly I cant play my games here.
their instructions install the version of the Config tool that I had already rollered back from..
so I followed their link downloaded a fresh copy and installed that one.. 

YAY this did nothing and I was in the same place as before.. 
 see the image I have added 

if you have VPC gear you will know that one device in the tool should be 1 device in the windows joystick tool

that 1 device is the throttle and the penal #1 plugged in correctly as you can see by it being just one device in the VPC tool.

Anyone Got any Idea's its obvious VPC have no clue as to what to do to fix this.. 

PS I am running windows 11 (yes I know.. but it is what it is) its how I bought the system..

null