Jump to content

Recommended Posts

Posted

Strange issue occured for me today - or at least I think it occured today - I havent been paying attention to which mode I was using for the last few days.

 

Tried to use mode 1 today, to load a specific aircraft mode:

Mode 1 - no friggin way - does not happen. No Green light. LCD says mode 2 at best.

Mode 2 and 3 - works fine. Blue & Purple light. LCD show correct mode.

 

Control Panel - Device, wathing the "button" in the calibration panel - swithing the mode - only mode 2 and 3 shows active. Mode 1 never does.

103626905_3-21-20103-06-34PM.jpg.8faa276b7c489f4379d92d3a883e9e36.jpg

Windows 7 x64 - tested on 2 different computers.

1 computer had Saitek profile software

1 computer with standard Win 7 drivers.

Same result.

 

 

Any further ideas? :(

Return the x52? Need to check if my warranty is valid.

The mind is like a parachute. It only works when it's open | The important thing is not to stop questioning

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...