Eyefinity, Bezel-Compensated Resolution

[siefex]

Hello all,

 

I have a 4 monitor setup (3x24" Dell U2410 for eyefinity and 1xAcer T230H Touchscreen). Since I use my monitors in various configurations throughout my day, I often have to switch in and out of eyefinity mode. As a result, when I change back to eyefinity mode in the evening to game and go through the whole bezel-compensation process, sometimes ATI does not give me the same horizontal resolution which I had during the previous evening. It all just depends on how exactly I use the bezel compensation tool.

 

Here's the problem: when placing MFCD's on my touchscreen or setting up custom snapviews, I need to always use the same eyefinity resolution as a baseline to accurately set the aforementioned, related values.

 

The obvious answer is to say "Use a profile!" Well, I've tried that but switching in and out of eyefinity profiles with CCC 11.2 does not work for me. CCC allows me to switch between non-eyefinity profiles just fine (usually), BUT if I try to switch from a non-eyefinity profile to an eyefinity profile (or vice versa), it won't work. Instead, if I'm switching from a non-eyefinity profile, CCC will just switches to my 3 24" U2410 displays mirroring one another in non-eyefinity mode. Just to note: I'm using two XFX 6950s in crossfire (although crossfire doesn't work in windowed mode with my touchscreen...)

 

If there was a way to fix my profile problem in CCC, that would fix my first problem of establishing a permanent, bezel-compensated resolution which will not change every time I switch in and out of eyefinity mode. With all that said, I welcome any advice people might have with regard tot his issue. Thanks!

Edited March 3, 2011 by siefex

[Buzzman]

+1 I would like a answer to this also.