secretkon8700 Posted May 20, 2011 Posted May 20, 2011 Tried a search but no joy, probably because i'm really not sure what to call this phenomenon. Ok, finally get my Cougar up and running, everything works... i'm THRILLED, I know it all works because i'm in the CCP Viewer screen and I can see it. I'm most excited about my ministick... I can move it any direction... but wait... what is it doing... what just happened!?! I pressed the ministick to the "down" position, and in the viewer, it slowly moves back to center, then does not respond anymore, just down on the Y axis. A reflash and dance gets it working again... until it happens again! Only the down axis again!! This happens usually around a minute or so after being set up and calibrated. ANY IDEAS?! :helpsmilie: Win 7 x64 w/2007 drivers, follow the cougarworld guide to the T.
KillaALF Posted May 20, 2011 Posted May 20, 2011 The pot of my ministick was flakey, it would always start to drift without any input from me. So I got in contact with TM tech support and ordered a new one. Unsoldering the old one from its mini PCB was a PITA and took me quite some time, but other than that the operation was a total success. The part (Double Pot 252A104B60NB) cost 8 Euros, shipping included.
Recommended Posts