Jump to content

Recommended Posts

Posted

hi is there a reason why when it is activated the vihkr doesn't seem to be corrected is it correctly implemented ?

even worse with canon or rocket it doesn't work

we need to go manual to aim moving target to adjust the speed of target :doh:

it shoulds work IRL ?

member of 06 MHR /  FENNEC Mi-24P

Posted

I'm not sure I understand what you mean. It works perfectly find for me, though obviously there are cases where it's good to use and cases where it isn't.

 

What specific function do you expect from it?

[sIGPIC][/sIGPIC]

Daniel "EtherealN" Agorander | Даниэль "эфирныйн" Агорандер

Intel i7 2600K @ 4.4GHz, ASUS Sabertooth P67, 8GB Corsair Vengeance @ 1600MHz, ASUS GTX 560Ti DirectCU II 1GB, Samsung 830series 512GB SSD, Corsair AX850w, two BENQ screens and TM HOTAS Warthog

DCS: A-10C Warthog FAQ | DCS: P-51D FAQ | Remember to read the Forum Rules |

|
| Life of a Game Tester
Posted

the gun shot should be corrected with the speed of the target but it doesn't work especially when we are on the side aspect of the target

 

the vihkr miss the target on side if i remember it should be more rarely so to prevent i aim the front side i should not have to do this:cry:

member of 06 MHR /  FENNEC Mi-24P

Posted

The gun corrects for target movement irrespective of the auto-turn button. Gun correction happens through the GMT function.

 

Vikhrs flight is also independent of the auto-turn. All the auto-turn does is translate your helicopter such that it points at the target without you having to do it manually; weapon aim is independent (for cannon, the cannon traverse, for Vikhrs the Skhval laser works independently). As for shots with a large lateral component, this is always more difficult for the missile and laser and has nothing to do with the auto-turn, it is caused by the Skhval laser grid moving faster than the Vikhr can maneuver.

[sIGPIC][/sIGPIC]

Daniel "EtherealN" Agorander | Даниэль "эфирныйн" Агорандер

Intel i7 2600K @ 4.4GHz, ASUS Sabertooth P67, 8GB Corsair Vengeance @ 1600MHz, ASUS GTX 560Ti DirectCU II 1GB, Samsung 830series 512GB SSD, Corsair AX850w, two BENQ screens and TM HOTAS Warthog

DCS: A-10C Warthog FAQ | DCS: P-51D FAQ | Remember to read the Forum Rules |

|
| Life of a Game Tester
Posted
The gun corrects for target movement irrespective of the auto-turn button. Gun correction happens through the GMT function.

 

Vikhrs flight is also independent of the auto-turn. All the auto-turn does is translate your helicopter such that it points at the target without you having to do it manually; weapon aim is independent (for cannon, the cannon traverse, for Vikhrs the Skhval laser works independently). As for shots with a large lateral component, this is always more difficult for the missile and laser and has nothing to do with the auto-turn, it is caused by the Skhval laser grid moving faster than the Vikhr can maneuver.

 

the auto turn doesn't have priority sometime it doesn't work :( (trim conflict)

too much load work for rockets

member of 06 MHR /  FENNEC Mi-24P

Posted
the auto turn doesn't have priority sometime it doesn't work :( (trim conflict)

 

Not a trim conflict. AP has a limited authority over your controls. If it didn't, a software error could send you into an irrecoverable departure. What you are experiencing is you not trimming correctly. If your trim is off and the AP has to use all it's authority to balance you from your erroneous trim, anything further on top of that will just not get done, because it does not have enough authority over the aircraft.

 

Auto-turn works through the same channels your normal AP stabs do. If you're badly trimmed, it can't do it's job.

[sIGPIC][/sIGPIC]

Daniel "EtherealN" Agorander | Даниэль "эфирныйн" Агорандер

Intel i7 2600K @ 4.4GHz, ASUS Sabertooth P67, 8GB Corsair Vengeance @ 1600MHz, ASUS GTX 560Ti DirectCU II 1GB, Samsung 830series 512GB SSD, Corsair AX850w, two BENQ screens and TM HOTAS Warthog

DCS: A-10C Warthog FAQ | DCS: P-51D FAQ | Remember to read the Forum Rules |

|
| Life of a Game Tester
Posted
Not a trim conflict. AP has a limited authority over your controls. If it didn't, a software error could send you into an irrecoverable departure. What you are experiencing is you not trimming correctly. If your trim is off and the AP has to use all it's authority to balance you from your erroneous trim, anything further on top of that will just not get done, because it does not have enough authority over the aircraft.

 

Auto-turn works through the same channels your normal AP stabs do. If you're badly trimmed, it can't do it's job.

 

because it does not have enough authority over the aircraft that's the explanation thx :)

member of 06 MHR /  FENNEC Mi-24P

Posted

To be precise, your trimming partially uses AP channels if they are active (and they should be, flying without them is an emergency procedure only IRL). Thus, bad trim will deteriorate the AP's ability to do other jobs.

[sIGPIC][/sIGPIC]

Daniel "EtherealN" Agorander | Даниэль "эфирныйн" Агорандер

Intel i7 2600K @ 4.4GHz, ASUS Sabertooth P67, 8GB Corsair Vengeance @ 1600MHz, ASUS GTX 560Ti DirectCU II 1GB, Samsung 830series 512GB SSD, Corsair AX850w, two BENQ screens and TM HOTAS Warthog

DCS: A-10C Warthog FAQ | DCS: P-51D FAQ | Remember to read the Forum Rules |

|
| Life of a Game Tester
  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...