-Ice Posted January 1, 2012 Posted January 1, 2012 Hey guys! I'm trying to create my own profile for VAC to control radio comms but at the minute, it seems like the radio comm is very confusing. For example, if you contact ATC and call inbound, all subsequent choices start off from the ATC sub-menu. However, if you press any of the other Mic switches (UHF, VHF FM), then go back to VHF AM, you have to start over from the main menu. To illustrate, if you were flying inbound and call in, it would be VHF AM -> (F5) ATC -> (F1, assuming it is the top/closest tower) Bantumi -> (F1) Inbound. Subsequent choices would be F1 - Abort Inbound and F2 - Request Azimuth. However, if you select UHF or VHF FM, then come back to VHF AM, you will have to select (F5) ATC again to get access to the Abort and Azimuth radio calls. Also, once you are near the runway and told to contact tower, the selection now is F1 - Request Landing, F2 - Abort Inbound, and F3 - Request Azimuth. The same applies for other radio sub-menus, in that you'll stay on them if you key the correct mic, but will have to go through the main radio menu if you click a different mic. Any help around this? - Ice
Recommended Posts