Clyber Posted February 25, 2013 Posted February 25, 2013 (edited) Hello there, Is there someone out there who can advise me a bit about my Monitor Setup ? Here i have 3 monitor running DCS [blackShark]. 3x. 1920x1080 27inch. using eyefinity. the other 3 monitors under the Eyefinity group are used for Helios. using Softth. Monitors 5&6. 2x23" touchmonitors resolution 1920x1080 Monitor 4 32" touchmonitor resolution 1366x768 I tought i need to use Eyefinity for the upper monitors and softth for the monitors below for Helios exports. i dont know if this is the right way to approch this, but this is what i have done: When i put the Game Resolution at 6084x2160. i have all the exports in place and the game is working . But i guess i have to much load on my GPU's because the ground/helicopter moves in a shock motion. While if i put the game resolution at 6084x1080 Just Eyefinity i works just fine. Do i need both Eyefinity and Softth for my setup or is there a way to have SoftTh taking over the Task from Eyefinity ? Because i read that SoftTh have Less FPS compaired to Eyefinity. What do i need to do to get this properly configured ?Tar.luaoptions.luaDxDiag.txt Edited February 25, 2013 by Clyber
Recommended Posts