Jump to content

Recommended Posts

Posted

Hi all,

Over the last few months my right throttle has become slightly loosened on the hinge bit inside. how do I take the base to bits to tighten it up again? I've taken the 5 screws out and taken the plastic cover off but where do I go from there? Thanks

MSI M5 z270 | Intel i5 7600k (OC) 4.8GHz | MSI GTX1080ti Gaming X 11Gb | 500gb Samsung 970 Evo NVME M.2 (DCS World) | 500gb Samsung 850 Evo SSD (OS and Apps) | 32Gb 2400MHz DDR4 - Crucial Ballistix | Be Quiet Silent Loop 240mm | NZXT H440 case |

 

Thrustmaster Warthog - 47608 with Virpil Mongoose joystick base | MFG Crosswinds - 1241 | Westland Lynx collective with Bodnar X board | Pilot's seat from ZH832 Merlin | JetSeat | Oculus Rift S | Windows 10 | VA |

Posted

Nobody take one apart then?

MSI M5 z270 | Intel i5 7600k (OC) 4.8GHz | MSI GTX1080ti Gaming X 11Gb | 500gb Samsung 970 Evo NVME M.2 (DCS World) | 500gb Samsung 850 Evo SSD (OS and Apps) | 32Gb 2400MHz DDR4 - Crucial Ballistix | Be Quiet Silent Loop 240mm | NZXT H440 case |

 

Thrustmaster Warthog - 47608 with Virpil Mongoose joystick base | MFG Crosswinds - 1241 | Westland Lynx collective with Bodnar X board | Pilot's seat from ZH832 Merlin | JetSeat | Oculus Rift S | Windows 10 | VA |

Posted
Nobody take one apart then?

 

I have replaced the PCB but that is it. I simply removed the screws on the bottom of the unit, then the screws on the circuit board itself. You may have to go n from the bottom in this manner to get at what you need to get at.

Hope this helps,

Fenmonster

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...