Jump to content

oakdesign

Members
  • Posts

    3
  • Joined

  • Last visited

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

  1. I use an basically empty profile with, So I delete shiftstaes 2-3-4 then I set the ministick to unprogrammed on shiftstate 1 and then delete shiftstate 1 and save. You won't be able to reopen that profile with the STT/MadCaz profile editor but leaves with a X65F where even the 4 mode buttons can be used as any other button and the ministick to be used axis and not as mousestick
  2. Yes I have. I'm using a 3d printed Lift detent on my X65 so I needed Idle Detent as well as AB detent. I achived it the following way. As you are only asking for AB detent I leave out the Idle detent part which would require to split the throttle axis in to 2 virtual axis. 1. this is for the DCS F-16 as i don't use other aircraft 2. In DCS Controls I have bound a keyboard command to "Cycle Afterburner detent On/Off 3. I'm using Joystick Gremlin to achive the AB detent. 4. In JG I have on the throttle Axis (Z-Axis) a macro with send the Keyboard command set in #2 5. On the macro virtual button I have set Activate when axis is between "-0.95" and "-0.90" when entering from "Anywhere" 6. In DCS Special for F-16 Afterburner detent is set to Always on
×
×
  • Create New...