NicolasDf

LS, I’ve been using this mod since release without an issue. However, after updating DCS this week (03/20/25), the MPD mod doesn’t work anymore for the SA page set on the MPCD. It only shows the link 16 symbols (wingman etc.) on a black screen. The SA set on the left or right MPD works fine, the problem is limited to the MPCD (center). I’ve tried a DCS cleanup and the SA page works fine on the MPCD with the mod disabled. Any advice would be appreciated. DN

LS, I’ve found a solution. Apparently some players had a similar issue on DCS MT and their workaround fixes the TCS and LANTIRN image problem on the VDI. I have this issue on the standard DCS but the same solution works too: Starting the mission from the mission editor gives a normal functionality for the imagery of the LANTIRN in the front cockpit. To get the bombs drop I jumped in to the rear cockpit and although on the armament panel all the switches were set correctly, I switched them all off and back on again as a reset and this worked. The strange thing is I only have had this issue in mission 12 of S&A. For all other missions the F14 works as advertised. In any case, problem solved. Thanks for your input, N.

LS, After eliminating the air threat the next step in the mission is to go and bomb a couple of ships close to WP1. This part of the mission does not work for me: I don’t have a LANTIRN video image in the front cockpit, only the Lantirn bezel. Also, the LGB12s don’t fall. I have tried by keyboard command and joystick but no joy. Jester does give guidance. I didn’t have this problem during the Nevada RAG AG training mission. Next step was to run a DCS repair which didn’t solve the problem. Any suggestions? And yes: all switches are set correctly in both cockpits as are the contrast and brightness for the VDI. I have trained extensively DCS AG missions for the F14 with the Lantirn and LGBs both as pilot and RIO. From my side this is a bug of sorts but nobody else seems to have this problem… so must be doing something wrong. N.

The aircraft is set up in the mission editor for multicrew with equal responsability for pilot and WSO. On a LGB bombing run with WSO in command of the TPOD, polarity set to WHOT. The pilot takes command with the castle switch and changes the TPOD polarity from WHOT to BHOT: the WSO screen remains in WHOT only to switch to BHOT when WSO takes command again. Presumably a bug because any change of settings by the crewmember in command of the screen should be visible for both crewmembers whether they are in command of the screen or not. N.

Sequencing waypoints on the TGP with PB17 or coolie up only works in ascending direction. Eg 1, 2, 3, 4 and then stops. There’s no way of sequencing back to 1. Restarting the procedure puts the sequence to a lower waypoint but never to 1. Eg sequencing from 1 to 8 has it stop at 8 but when restarting the procedure it starts from 4 etc. making it impossible to use if your target is WP 3. N.