Strelac

Colin, do you mind describing in detail what you did to get t to work. I have 1.01 as well, but only some textures are showing even with the recommended install steps. For example the back texture and floor is still vanilla low res. If anyone else has suggestion, it's appreciated as well. Rgds Cancel the above. I got it to work :thumbup: What a difference. Riccardo thank you for all your hard work. The pit is now finally as it should be. If someone else with 1.01 still has issues, just edit the graphics.cfg in your game C: folder with strings from the install guide. Make sure that you put the strings under "TextureCollections" set

Apologies, if this has been covered somewhere else. I have been searching all over this forum for reports of similar issue, but could not find anything. In the GWO 1 campaign, there are few missions where requirement for success is to do recon on several WP deep inside enemy territory. When I creep up to the WP, the message is displayed on the screen “Objective x completed”, where X is the number of objective. I then check the mission status, and see the points added toward mission completion. So far so good. The issue arises after I exit that WP zone. The score I just earned for that recon WP is cleared, but no message is displayed. If I come back to the same zone, the points appear again. I have flown only one recon mission where everything was OK, but all other I encounter come with the same issue. :( Now sure if it’s something I do wrong, or flag counters are reset incorrectly. I am using 1.01 version Any help is appreciated.