felixx75

If you have deactivated (or not activated) the mouse for the jester wheel in the special options, entering numbers in the field hardly ever works (problems with the focus). You must currently have activated mouse for the Jester Wheel. Afaik HB is working on a solution.
Edit: too late @Zabuzard was quicker 😉

As far as I know, the fastest method is "ALCM", a stored heading alignment (must be set in the editor for the mission, afaik). This takes about 90 seconds.
If you want a full alignment, the only option is a hot start or a cold start with the full 8 minute alignment.

It works as intended.
 

I asked a Dev and got the following answer, which probably explains everything:
 
"Hey, thanks for reaching out. The movement of the 3d model of the stick in the cockpit goes through a type of low-pass-like filter. Otherwise, it might look erratic and actually even less realistic. However, it doesn't represent the actual physical simulation of the entire stick simulation, and that means that the change of your input is instantaneously transferred to the controls system. Yet, that system runs a complex simulation that adds realistic inertia to the mechanisms that transfer your input to the power actuators.
To summarise, the lag you may see when observing the 3D controls doesn't represent the system's delay; there might be some realistic inertia reducing the controls' responsiveness.
I hope I managed to explain it. If you have additional questions, I'll be happy to answer them.
Best regards"

It's a bug.
https://forum.dcs.world/topic/347485-routing-does-not-work/?do=findComment&comment=5419974
https://discord.com/channels/542985647502393346/835124559987998730/1231973269750550558

I have received confirmation in the ED Discord that it is indeed a bug, which is also known internally and is being worked on.