Hi, I've been learning the DCS-Bios framework for a couple of weeks but have got stuck on the following. I've set up a cmsp on a 2x16 LCD panel. The cmsp code is based on the code provided in another thread on this forum. It works fine until I add an LED handleGearWarning line to the code. Then only one character from the end of the second line is displayed (e.g., the G from PROG), the earlier characters are blank spaces, the first line displays as it should. I've used both a DUE and a Mega and seem to get the same issue (using version 0.2.2 with 0.5.0).
Code is listed below - any help appreciated.
#define DCSBIOS_DEFAULT_SERIAL
#include "DcsBios.h"
#include <LiquidCrystal_I2C.h>
LiquidCrystal_I2C lcd(0x3F, 16, 2);
DcsBios::LED handleGearWarning(0x1026, 0x4000, 7); // <-- this line causes a problem
void onCmsp1Change(char* cmsp1) {
lcd.setCursor(0,0);
lcd.print(cmsp1[0]);
lcd.print(cmsp1[1]);
lcd.print(cmsp1[2]);
lcd.print(cmsp1[3]);
lcd.print(cmsp1[5]);
lcd.print(cmsp1[6]);
lcd.print(cmsp1[7]);
lcd.print(cmsp1[8]);
lcd.print(cmsp1[10]);
lcd.print(cmsp1[11]);
lcd.print(cmsp1[12]);
lcd.print(cmsp1[13]);
lcd.print(cmsp1[15]);
lcd.print(cmsp1[16]);
lcd.print(cmsp1[17]);
lcd.print(cmsp1[18]);
}
DcsBios::StringBuffer<19> cmsp1Buffer(0x1000, onCmsp1Change);
void onCmsp2Change(char* cmsp2) {
lcd.setCursor(0,1);
lcd.print(cmsp2[0]);
lcd.print(cmsp2[1]);
lcd.print(cmsp2[2]);
lcd.print(cmsp2[3]);
lcd.print(cmsp2[5]);
lcd.print(cmsp2[6]);
lcd.print(cmsp2[7]);
lcd.print(cmsp2[8]);
lcd.print(cmsp2[10]);
lcd.print(cmsp2[11]);
lcd.print(cmsp2[12]);
lcd.print(cmsp2[13]);
lcd.print(cmsp2[15]);
lcd.print(cmsp2[16]);
lcd.print(cmsp2[17]);
lcd.print(cmsp2[18]);
}
DcsBios::StringBuffer<19> cmsp2Buffer(0x1014, onCmsp2Change);
//---------------------------------------------------------------------------------------------
void setup() {
DcsBios::setup();
lcd.begin();
lcd.backlight();
lcd.print("ready");
}
void loop() {
DcsBios::loop();
}
