tstrck

Thanks but I have already used the last beta (2.0.0.6) for DCS 1.5 and... It's very unstable! I should downgrade DCS to 1.2... but I wouldn't.

Yes, I know. I did it in order to center the outputs in each MFCD handmade. So isn't possible switch off the "cockpits mirroring effect" in these outputs?

Thank you. Just a question about an issue: how to remove the two " mini cockpit " from the MFDs ? Camera+2MFCD.lua

Done. :smilewink:

Hi all, I'm following this amazing MFD project and I wish help the community with my little contribute. I rescaled the drawing from inch to decimal (mm) and I modified the layout for A3 sheet. I did that cause I found an on-line plexiglass cutting service in my country (Italy). If there are some italian users, I report the link: http://www.matterlab.it/taglio_laser/en/content/9-taglio-laser http://www.matterlab.it/taglio_laser/en/taglio-incisione-laser-su-pmma-plexiglass/715-laser-cutting-on-plexiglas-20-mm-thick.html I sent the drawing yesterday evening, right today they shipped my order. I also modified the design for the VS-TY2662-V1 driver board. I will keep you updated. Bye! MFC-print_dec.zip