colinwilloughby

I have looked everywhere for the Kaiwa manual, Is there one available??

That solves all the problems. I have attempted to place an F16 on the deck. Thank you all for the feedback (Its all a learning curve) Thanks again

Hi again guys, Another problem has shown up. I cannot get my aircraft to stay with the carrier, When I place the aircraft on to the carrier, the selection for positioning is an airfield only list. Click on any on the list and the plane will jump to the nearest airfield. The list for carrier positioning is not available.

Thank you guys, I did not know about the models button. Now I have the carrier. Thanks again

In Mission Editor I place the Supper Carrier (or any other ship) on the map, The Icons are there with the radar range circles showing but when I zoom in, the carrier (or other ships) are not there so it's not possible to install my aircraft on the carrier. Can anyone please enlighten me as to the problem. I have in the passed carried out placing the carrier, installing and flying the Hornet. I have recently re-installed windows and DCS. All other functions in DCS are working fine.

Viocom not responding to the Lctr//Lalt/C. Re-installed with the latest version of VA but no effect, no beep/no indication. the program just stopped working hens the re-install. I have validated VA, enabled plugin, run as admin but no response to the keys.

A late reply, thank you for your advise, but it does not bring up the window, I have to keep re-installing to continue functionality Thank you again

Thanks "H" for your reply, However, Still cannot get the config to show on screen just a blank page view in the task bar. I must again mention that when reinstalled, config will work well on both monitors for a short while. Regards Colin

Yes, everything is showing and accessible.

I run two monitors VA as Admin Kaspersky internet security All above have run OK in the past with VA

Yes, Chatter and realistic ATC

When voice Attack has initialized, pressing LCtrl+LAlt+C for config does not bring up viocom config window to my desktop. A blank view of it can be seen in my task bar. This has happened a number of times and the only I can fix it is by re-installing but this does not last, after a few loads it fails to show again. Appreciate any Help

When voice Attack has initialized, pressing LCtrl+LAlt+C for config does not bring up viocom config window to my desktop. A blank view of it can be seen in my task bar. This has happened a number of times and the only I can fix it is by re-installing but this does not last, after a few loads it fails to show again. Appreciate any Help

F18/J82s/targeting POD. The first problem when first trying out the POD, was after going through the recommended procedure with four Bombs selected and targets set on each, most of the bombs landed way of target and one in the opposite direction. I checked many times with Wags video and any other video covering J82 with targeting pod. But I could not see any difference in my set up. I then received and installed the recent auto update for DCS. 2.5 Open Beta. But then, Running through the following procedure; J82. Time out. PP mode or TOO (same results). Fuse- Inst, Display. Quantity-4. Return. TOO, Mission, set perimeters, change back tp PP. when STEP selected the mode will re-select TOO mode and will not stay in PP mode. The result is all other selected weapons will get over written and target the first selected target or go adrift to some where way off course. When a single Bomb is chosen, the system is ok “IF” first chosen. If I try single after attempting Multiple, then I have to come out and chose stores again and then go through the process of a single drop. Any suggestions:(???

Thanks guise for your reply. I have not been on the Hornet for some time (Ka50). thought I would go back and give it a try. I did not carry out the correct start up procedure, no fuel till the generators kick in. All is well. Thanks again