kips
-
Posts
12 -
Joined
-
Last visited
-
The problem is still there, it depends on the planes in the parking lot.
-
I went too fast, on the first mission I get stuck with the message waiting for staff. Campaign configuration with FA-18C_hornet | VFA-106 | CVN-71 Theodore Roosevelt and on the deck several aircraft in parking see screenshot 1. in the other parking configuration it works, screenshot 2. I tested with and without cold start.
-
Ok, it works, I did a game repair by verifying all game files and now everything works normally. Sorry I didn't think of it before but thanks for the follow-up. -
-
Yes, I perform the salute and after nothing...as you can see in the screenshot above
-
I probably expressed myself badly, I actually appear on the bridge and I am not managed by the crew. By deactivating the bridge crew, I can take off but 2 of my wingmen remain stuck on the bridge.
-
Thank you for your feedback. To start the campaign, I had to disable deck crew in the DCS super carrier configuration. Because I was still stuck after performing the salute. Yes, of course, I used DCE Manager as indicated in the campaign documentation. I reset the campaign, and I don't have the same information as you in the screenshot.
-
Hello, Thank you for your work! - In the TF-71 campaign it is necessary to destroy SA-10 sites with AGM 84H slam ER, while they are all systematically intercepted. Is there a method to effectively use AGM 84H against SA-10 sites? - I've set up the campaign as described in the document (I hope). I'm playing solo in F18, and after greeting, I'm stuck with the "waiting for personnel" message. Any ideas on the problem? (Apart from the keyboard and the seat ) DCS 2.9.17.12034
-
yesss! great Thanks! Joypro with Exchange Device is ok.
-
I'll watch it and come back to let you know
-
THX, That's what I feared
-
Hello, I replaced my Hotas X55 with the X56, they are physically almost identical. Is there a way to avoid configuring the X56 by migrating the conf from the X55? Thanks in advance.
-
Bonjour, J'ai remplacé mon Hotas X55 par le X56, il sont physiquement quasi identiques. Existe t-il un moyen d'éviter de configurer le X56 en migrant la conf du X55? Merci d'avance.
