Tinysnipe

Yep, that seemed to do it, a lot easier than I thought :).

Thank you, will try it now.

Is there a way to make trucks keep moving when being fired at? Because I know how to do it for stationary trucks, but not for trucks moving to different waypoints.

Well also because of how classified the plane is, and I'm sure there is some information you can't get, so for that classified information would you have to adapt, or what is the plan for that?

Welcome, Glad to see a new face among DCS, especially moving to be my favorite because of this being one of all-time favorites. Best luck to you!

Thank you for the help both of you!

I am wondering if there is a way to make the enemy planes passive for a training mission, because it is a little better than what I have been previously doing of using friendly planes.

Ok, thank you, can finally learn the full potential of her now. :)

So I did that but all it does is cycle between changing of Latitude, longitude, or altitude.

So for the past week I have been fiddling around with the UFC buttons after my alignment is complete. I have still not figured out how to get out of it, because every time I click 1 to go to my tacan and ILS page it only types in 1 for either the coordinates or height in the INS page.

So sorry to change it up (and the wait for my response) but it turns out that it is not my mission the problem, but something in my settings. Because i tried other DCS made missions and the F10 map didn't work.

Thank you for the response, Yes I use TrackIR but not of the buttons for TrackIR are bound with F10.

I suddenly started having problems with my F10 just not working in my mission I made. I was wondering what could be the problem since I have my F10 bound to the correct key along within the mission editor I have F10 map enforced. Anyone what the problem could be?

If at all possible could you send a video of your startup process so I can cross-examine mine? Because if you say they have different functions at different times then I'd need to know how to get out of the INS alignment page. P.S. I have tried a cold start from Matt Wagner and I still run into the same problem.

If at all possible could you send a video of your startup process so I can see what I am doing differently?

I started to notice a problem where I can only see my INS page when I was trying to learn how to use the TACAN and the ILS system. the only buttons that are responsible for changing the UFC display are these ones...