NEODARK Posted March 22, 2006 Posted March 22, 2006 Hey guys, I've recently reinstalled lock on due to a hard crash. I was able to save all the previous data in the lockon folder. So far I've been able to restore the sounds I used, and a couple of other things, but the config.ini didnt seem to store the sensitivity/curves of my axis for roll, pitch, yaw, rudder or trim.. I spent countless hours tweaking to my liking and I cannot find where these were stored... can someone please point me to the right files to copy from my old install to the new one so that my axis can be restored? thanks in advance...
Lixma 06 Posted March 22, 2006 Posted March 22, 2006 Just copying the whole 'Input' folder across should do it....you may as well drag the whole 'Config' folder over, too. But... If you are going to run a different version of LOMAC (a later patch, perhaps) than the one that died then i wouldn't bother. It may cause you more hassle than just re-doing the key/axis assignments from scratch.
NEODARK Posted March 22, 2006 Author Posted March 22, 2006 nope, same 1.12. UPDATE: I copied the folders over and somehow it didnt "take", but I guess its not too bad, I think Im getting close to my old setup. Thanks. PS: I'm still off a bit ;) :icon_supe Oh, this is what lockon looks like on a 7900GTX 512 (4XTSAA 16AF + in game settings absolutely maxed out) thanks guys :)
Recommended Posts