9.JG27 DavidRed Posted December 5, 2014 Posted December 5, 2014 ok...not too sure yet whether its a bug, but i couldnt get this to work yet... while with the fw190 you can set frequencies on the 4different channels, and then be able to home in on beacons if the radio is set up properly, this doesnt seem to be possible with the 109. the needles of the afn2 gauge dont seem to move at all, even if set up properly(?) in the mission editor. BUT: it seems a different way was chosen with the 109 while development, as for example the afn2 gauge will automatically give you a warning light when passing one of the markers placed by default on the map.this isnt the case in the 190, or at least it wasnt the case before the last patch. i looked at the manual, but on page 106 it says: FuG16 Homing Switch The Homing Switch can be set to one of two positions, FT FT (Funkturm or Radio Tower) and Y ZF now i dont see this homing switch,..at least it is not labeled the way it is described in the manual...there is a EIN and AUS switch in the cockpit though, which seems to be responsible to home in...but so far it seems that all this switch does is to additionally give an audible warning signal to the visible warning light in the AFN2 gauge.but still the needles just wont move. its interesting though as in the mission editor there is now a new tab under the 109 properties for homing.but it doesnt seem to work.
Recommended Posts