Jump to content

Outside textures in cockpit view are not aligned with windshield


Sporg
 Share

Recommended Posts

The outside textures of the cockpit view are not fully aligned:

1. You can see the ground through the flare gun hole outside

2. When leaning your head close to the windshield sides or front, the outside fairing textures do not fit flush with the edge of the windshield, and in front of the windshield there is a square hole.

 

Shreenshots are shown below:

 

attachment.php?attachmentid=113740&d=1425121473

 

attachment.php?attachmentid=113741&d=1425121473

 

attachment.php?attachmentid=113742&d=1425121473

System specs:

 

Gigabyte Aorus Master, i7 9700K@std, GTX 1080TI OC, 32 GB 3000 MHz RAM, NVMe M.2 SSD, Oculus Quest VR (2x1600x1440)

Warthog HOTAS w/150mm extension, Slaw pedals, Gametrix Jetseat, TrackIR for monitor use

 

Link to comment
Share on other sites

Ground can also be seen behind rudder pedals.

 

attachment.php?attachmentid=113750&d=1425125120

 

attachment.php?attachmentid=113751&d=1425125120

System specs:

 

Gigabyte Aorus Master, i7 9700K@std, GTX 1080TI OC, 32 GB 3000 MHz RAM, NVMe M.2 SSD, Oculus Quest VR (2x1600x1440)

Warthog HOTAS w/150mm extension, Slaw pedals, Gametrix Jetseat, TrackIR for monitor use

 

Link to comment
Share on other sites

  • 1 month later...

Hello,

 

i have got exactly the same issues after the last updates. Any solutions? I have already removed and re-installed the BF-109 in DCS World final and beta.

But this does not work for me!

 

If i remeber correctly, the damage model of the cowlings was tweaked. I think since then i have got this problems.

 

By the ways all other modules seem to work fine so far!

With kind regards!

Link to comment
Share on other sites

 Share

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...