Tinkickef Posted July 17, 2016 Posted July 17, 2016 (edited) Since the recent update, starts out fine, if a little close to the panel, then after a couple of missions, the seat to panel orientation goes to around 45 degrees off centre. Pressing numberpad 5 to recentre either makes it 45 degrees the other way or a full 90 degrees and you end up sat cross cockpit. When you press the fly button before the start of the mission, where the "loading screen" is orientated seems to have some bearing on the eventual cockpit orientation. A temporary fix is to carry out a full reorientation in oculus home, but the problem soon reemerges. Only occurs in DCS, when you exit back to oculus home everything is normal again and is also normal in all my other games. Def a bug in DCS. Edit. Def loading screen related. When loading mission, if you look around, the loading screen moves and that is where your cockpit orientation will be. Have to stare hard at the nose of the hog during loading to prevent it. Edited July 25, 2016 by Tinkickef System spec: i9 9900K, Gigabyte Aorus Z390 Ultra motherboard, 32Gb Corsair Vengeance DDR4 3200 RAM, Corsair M.2 NVMe 1Tb Boot SSD. Seagate 1Tb Hybrid mass storage SSD. ASUS RTX2080TI Dual OC, Thermaltake Flo Riing 360mm water pumper, EVGA 850G3 PSU. HP Reverb, TM Warthog, Crosswind pedals, Buttkicker Gamer 2.
S D Posted September 16, 2016 Posted September 16, 2016 Have you got the "reset VR" button set? Its just like re-centre on the TrackIR. As long as your rift calibration is done and the sensor does move between sessions. The reset VR can be used to adjust for any changes in your position.
Recommended Posts