Hornetjock Posted April 13, 2018 Posted April 13, 2018 Having successfully loaded the Spitfire, my CH Fighterstick is fluttering in the sim and not smoothly operating the elevators. I have tried setting the axis tune to that of the TF P 51, which works well. Am I missing something?
Hornetjock Posted April 13, 2018 Author Posted April 13, 2018 I did a re-calibration in CH control manager and un-re-plugged. Tried various slider settings no joy.
Kappi Posted April 13, 2018 Posted April 13, 2018 Did you try to set a dead zone on the axis? Helps me for my fluttering zoom axis. ___________________________________________ [sIGPIC][/sIGPIC] Looking forward to it, Belsimtek!:thumbup:
Hornetjock Posted April 14, 2018 Author Posted April 14, 2018 Problem resolved! When in doubt...read the manual! I went to Input Controller Walk Through and just followed the steps. I noticed that pitch and roll (stick) was only in the one column on the demo, but on mine it was also on my throttle controller, so I highlighted them and hit "clear" so that only one controller had the command. Same for throttle - I cleared it from the stick column. If anyone has this "fluttering" issue - that will be because one command is allocated to both controllers. Thanks and I hope this helps someone else.
smallberries Posted April 14, 2018 Posted April 14, 2018 Yeah, that is common to all modules in DCS. Any time you get a new module, and in any event that an update wipes your control schema, all the axis get bound to all available controllers, as well as the camera controls in the keybinds. A good habit is to backup your input .luas somewhere, and with a new module to clear all the columns before setting up your keybinds.
Recommended Posts