bones1014 Posted July 30, 2018 Posted July 30, 2018 I have a Logitech G13 keypad that I'm trying to map the armament panel switches. I have the controls all set but when I press the mapped key the switch doesn't operate properly. When just press the key combo on my keyboard it works better. Any thoughts on why it's doing that?
Norsegunar Posted July 30, 2018 Posted July 30, 2018 Are you programming it via the Logitech Software ? Specs: It's a computer...it runs DCS.... Audentes Fortuna Juvat [sIGPIC][/sIGPIC]
Norsegunar Posted August 2, 2018 Posted August 2, 2018 Sorry took me awhile to test this with my G-13. I was able to setup key pushes with Keystrokes. Few things: 1. Make sure you have under Properties for the Profile that it's assigned to the correct DCS.exe which is in the bin folder in your DCS install. 2. Make sure the key commands are mapped in DCS that you are mapping into the profile in Logitech Gaming software. 3. Make sure when you're in DCS that the profile is active on the G-13 Hope this helps Specs: It's a computer...it runs DCS.... Audentes Fortuna Juvat [sIGPIC][/sIGPIC]
defeatist99 Posted August 4, 2018 Posted August 4, 2018 Sorry took me awhile to test this with my G-13. I was able to setup key pushes with Keystrokes. Few things: 1. Make sure you have under Properties for the Profile that it's assigned to the correct DCS.exe which is in the bin folder in your DCS install. 2. Make sure the key commands are mapped in DCS that you are mapping into the profile in Logitech Gaming software. 3. Make sure when you're in DCS that the profile is active on the G-13 Hope this helps I've got one I haven't used in forever. Couldn't you just use it as a controller and bind it that way? I feel like that would be easier.
.thumb.jpg.1cfd8e192c4c6fd8e29874bf11ed6d7c.jpg)
Recommended Posts