Sgt_Fresh Posted December 21, 2018 Posted December 21, 2018 Either after take off or starting a mission in flight my rear stabilizer moves to the far down position creating a death configuration where I will eventually stall out and crash or burn up all my fuel running full afterburner while flying with a giant air brake on. I press / hold down / or tap the trim down button and the stabilizer eventually moves up but it over corrects and goes full up creating yet another death configuration. I still am unable to use auto pilot and Cycling the Flaps Auto -> Half -> Full -> Half -> Auto, will not trim out the plane. I re set the axis sensitivity as recommended on my hotas no go. The F18 is pretty much un-playable or too much work for any flight sim. Is there anything else I can do to level out the F18?
Vatikus Posted December 21, 2018 Posted December 21, 2018 Make sure to double check if there might be a problem with cross control mapping (it can happen that you get more devices mapped to the same function with default settings) Next one to try is dead zone setting. In my config I had a problem if it was set to 0.
Sgt_Fresh Posted December 21, 2018 Author Posted December 21, 2018 Make sure to double check if there might be a problem with cross control mapping (it can happen that you get more devices mapped to the same function with default settings) Next one to try is dead zone setting. In my config I had a problem if it was set to 0. Thanks i just got a new stick & throttle, I will check for cross control mapping.
Recommended Posts