TheConqueror Posted January 6, 2019 Posted January 6, 2019 I did 1 mission for me. And Jtac just giving info about target but no lasing... ? What is wrong ? Can you tell me how can i setup JTAC then i can check my JTAC setup :huh:
Yoda967 Posted January 7, 2019 Posted January 7, 2019 What unit are you using as a JTAC? Can you post your mission .miz file so folks can take a look? Very Respectfully, Kurt "Yoda" Kalbfleisch San Diego, California "In my private manual I firmly believed the only time there was too much fuel aboard any aircraft was if it was fire." --Ernest K. Gann
TheConqueror Posted January 7, 2019 Author Posted January 7, 2019 What unit are you using as a JTAC? Can you post your mission .miz file so folks can take a look? APC M1126 Stryker ICVAV8B Airdefence Training.miz
dooom Posted January 7, 2019 Posted January 7, 2019 make sure you are following instructions from JTAC as well.. most folks ignore the ingress direction orders and cause the JTAC to fall silent. Line of sight is another issue as is using a JTAC unit that cannot lase. ASUS Tuf Gaming Pro x570 / AMD Ryzen 7 5800X @ 3.8 / XFX Radeon 6900 XT / 64 GB DDR4 3200 "This was not in the Manual I did not read", cried the Noob" - BMBM, WWIIOL
TheConqueror Posted January 7, 2019 Author Posted January 7, 2019 (edited) make sure you are following instructions from JTAC as well.. most folks ignore the ingress direction orders and cause the JTAC to fall silent. Line of sight is another issue as is using a JTAC unit that cannot lase. Jtac talking with me but not lasing... Problem this. Just giving cordinate. OH i found problem i guess. Problem is about altitude... Edited January 7, 2019 by TheConqueror
Recommended Posts